Xerox Phaser 4600 Service Manual page 63

Y N
Remove the Right Cover (REP 7.25) and reseat CN7 on the Feeder Board, then retest.
The Feed Drive Assembly rotates.
Y N
Replace the Feed Drive Assembly,
Reassemble and perform SCP 6 Final Actions.
Replace these components in order until the error is corrected.
1. Feed Assembly, PL 8.40 Item 10
2. Pick Assembly, PL 8.20 Item 17
Revised
Phaser 4600/4620/4622 Printer Service Manual
REP 8.42.
08-400-00 Jam in Tray 4 RAP
08-400-00 Media remains in the Tray 4 Pick-up Assembly.
BSD-Reference:
WD 13
Initial Actions
1. Check media condition.
2. Check for obstructions in the media path.
3. Check for worn or damaged rollers.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Nudger, Feed, and Separator Rollers for excessive wear or contamination. The
rollers are undamaged and clean.
Y N
Clean or replace the rollers.
Check for obstructions or debris in the media path. The media path is clear.
Y N
Clear the media path of obstructions or debris.
Check Tray 3 Pick Assembly (PL 8.20 Item
Y N
Repair improper pick assembly motion.
code 08-400 to test the Take Away Sensor. The sensor signal changes (high/
Select dC330
low).
Y N
Remove the Right Cover (REP
The sensor signal changes.
Y N
Replace the sensor, REP
Reassemble and perform SCP 6
code 08-840 to test the Feed Clutch. The clutch is engaged (on/off).
Select dC330
Y N
Remove the Right Cover (REP
The clutch is engaged.
Y N
Replace the Feed Clutch,
Reassemble and perform SCP 6
code 08-940 to test the Feed Drive. The Feed Drive Assembly rotates (on/
Select dC330
off).
04/2016
2-39
WARNING
17) motion. Pick assembly motion is good.
7.25) and reseat CN3 on the Feeder Board, then retest.
8.44.
Final Actions.
7.25) and reseat CN9 on the Feeder Board, then retest.
REP 8.41.
Final Actions.
2 Status Indicator RAPS
08-300-00, 08-400-00