Xerox Phaser 4600 Service Manual page 51

07-320-00 Tray 4 is Open RAP
07-320-00 The Tray 4 Size Switch indicates Tray 4 is open.
BSD-Reference:
WD 13
Initial Actions
1. Close the Tray.
2. Check the Size Switch.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Remove Tray 4 and inspect the Size Switch. The Size Switch is undamaged.
Y N
Replace the Size Switch, REP 7.30, then retest.
code 07-400 to test the switch. The switch signal changes (open/closed).
Select dC330
Y N
Remove the Right Cover (REP 28.2) and reseat CN5 on the Feeder Board, then retest.
The sensor signal changes.
Y N
Replace the Feeder Board, REP
Reassemble and perform SCP 6 Final Actions.
Replace these components in order until the error is corrected.
1. Size Switch, PL 8.30 Item 9
2. Feeder Board, PL 8.30 Item 7
3. MCU Board, PL 3.10 Item 3
Revised
Phaser 4600/4620/4622 Printer Service Manual
WARNING
7.28.
07-330-00, 07-331-00 Jam in Tray 4 RAP
07-330-00 Jam 0 in Tray 4. Media remains in the Tray 4 Pick-up Assembly.
07-331-00 Check Tray 4 Feed Area. Media remains at the Tray 4 Take Away Sensor.
BSD-Reference:
WD 13
Initial Actions
1. Check for obstructions in the media path.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Nudger, Feed, and Separator Rollers for excessive wear or contamination. The
rollers are undamaged and clean.
Y N
Clean or replace the rollers.
Check for obstructions or debris in the media path. The media path is clear.
Y N
Clear the media path of obstructions or debris.
Check Tray 3 Pick Assembly (PL 8.20 Item
Y N
Repair improper pick assembly motion.
code 08-840 to test the Feed Clutch. The clutch is engaged (on/off).
Select dC330
Y N
Remove the Right Cover (REP
The clutch is engaged.
Y N
Replace the Feed Clutch,
Reassemble and perform SCP 6
code 08-940 to test the Feed Drive. The Feed Drive Assembly rotates (on/
Select dC330
off).
Y N
Remove the Right Cover (REP
The Feed Drive Assembly rotates.
Y N
Replace the Feed Drive Assembly,
Reassemble and perform SCP 6
Replace these components in order until the error is corrected.
1. Feed Assembly, PL 8.40 Item 10
04/2016
2-27
WARNING
17) motion. Pick assembly motion is good.
7.25) and reseat CN9 on the Feeder Board, then retest.
REP 8.41.
Final Actions.
7.25) and reseat CN7 on the Feeder Board, then retest.
REP 8.42.
Final Actions.
2 Status Indicator RAPS
07-320-00, 07-330-00, 07-331-00