Chapter 18. Catalytic Panel; Detaching Catalytic Panel; Chapter 19. Rack Positions; Installing And Removing Wire Racks - Kernau KBOS 641 B G User Manual

2. Remove the screws on the left and right sides as shown in Figure 13. Remove the profile by pulling it
towards you as shown in Figure 14. Glass will be free after the profile is removed as shown in Figure 15.
Carefully pull the glass that has become free toward you. If necessary, the middle glass can also be removed
in the same way. The outer glass is fixed to the oven door profile. You may easily clean the glass once it has
been released. Once the cleaning and maintenance is complete, you can replace the glasses and the profile
by performing the removal procedure in reverse. Make sure that the glass is inserted in the correct direction
and that the profile is seated properly.
Fig. 13
It is located behind the wire racks of the oven, at the right and left walls of oven cavity. Catalytic panel
removes offensive odour and provides using your appliance at its best performance. Over time, oil and food
odours permeate into enamelled oven walls and heating elements. Catalytic panel absorbs any food and oil
odours, and burns them during cooking to clean your oven.

DETACHING CATALYTIC PANEL

To remove catalytic panel; first remove the wire racks. Once wire racks are removed, catalytic panel will be
free. It is advised to replace the catalytic panel once every 2-3 years.
Rack 4
Rack 3
Rack 2
Rack 1

INSTALLING AND REMOVING WIRE RACKS

To remove wire racks, press the clips shown with arrows in the figure, first remove the lower, and than the
upper side from installation location. To install wire racks; reverse the procedure for removing wire rack.
Fig. 14

CHAPTER 18. CATALYTIC PANEL*

CHAPTER 19. RACK POSITIONS

It is important to place the wire grill into the oven
properly. Do not allow wire rack to touch rear
wall of the oven. Rack positions are shown in
the next figure. You may place a deep tray or a
standard tray in the lower and upper wire racks.
65
2
1
Fig. 15