Operate Panel Ts A Display - Kernau KBO 1067 SK B Operation Manual

OPERATE PANEL
Setting the current time
When the appliance is plugged into the electrical
mains supply, or when power is restored after power
outage, the digital display will show flashing „0.00".
• Touch and hold MENU or simultaneously
touch < / >) until you will see
on the display and the dot below the
symbol is flashing
• Touch < / > within 7 seconds to set
the current time.
To store the new time setting, wait approximately
7 seconds after time has been set. The dot below
the symbol will stop flashing. You can adjust
the time later. To do this touch < / >
simultaneously and adjust the current time while the
dot below the symbol is flashing.
NOTE:
The oven can be turned on when you see the symbol on the display.
Kitchen Timer
You can active the Kitchen Timer at any time, regardless of the status of other functions. The Kitchen
Timer can be set from 1 minute up to 23 hours and 59 minutes.
To set the Kitchen Timer:
• Touch MENU, then the display will show blinking
• Use the < / >, sensors to set the Kitchen Timer. The display will show the set time and
Kitchen Timer symbol . Once the set time elapses, alarm sounds and the icon flashes.
• Touch and hold < / > or MENU to mute the alarm. The will be off and the display will
show the current time after approximately 7 seconds.
NOTE:
If no button is touched, alarm will turn off automatically after approximately 7 minutes.
Timed operation
To set the appliance to switch off after a specific duration:
• Set the function selector knob and the temperature selector knob to your preferred settings.
• Touch MENU repeatedly until the display shows dur (duration) briefly and the
will be flashing.
• Set the desired duration from 1 minute to 10 hours using the < / > sensors.
- select the mode of operation
MENU
- higher setting sensor
- lower setting sensor
- appliance on indicator
- Kitchen timer
- Duration
- End Time
EN 41
symbol