Important Warnings For Installation; Right Place For Installation; 60 Cm Built-In Oven Installation And Mounting; Installation Under Counter - Kernau KBOS 641 B G User Manual

IMPORTANT WARNINGS FOR INSTALLATION:

Figure 1.

RIGHT PLACE FOR INSTALLATION

Product has been designed to be mounted to worktops procured from market. A safe distance must be left
between the product and kitchen walls or furniture. See the drawing provided on the next page for proper
distances. (values in mm).
• Used surfaces, synthetic laminates and adhesives must be heat resistant. (minimum 100 °C)
• Kitchen cupboards must be level with product and secured.
• If there is a drawer below the oven, a rack must be placed between oven and drawer.
WARNING
Do not install the product next to refrigerators or coolers. The heat emitted by the product
increases the energy consumption of cooling devices.
WARNING
Do not use door and/or handle to carry or move the product.

60 CM BUILT-IN OVEN INSTALLATION AND MOUNTING

Place of use for product must be located before starting installation. Product mustn't be installed in places
which are under the effect of strong air flow.
Carry the product with minimum two people. Do not drag the product so that floor isn't damaged.
Remove all transportation materials inside and outside the product. Remove all materials and documents
in the product.

INSTALLATION UNDER COUNTER

Cabin must match the dimensions provided in figure 2.
A clearance must be provided at the rear part of the cabin as indicated in the figure so that necessary
ventilation can be achieved.
After mounting, the clearance between lower and upper part of the counter is indicated in figure 5 with "A".
It's for ventilation and shouldn't be covered.
Cooling fan shall take extra steam out and prevent outer
surfaces of appliance from overheating during operation
of oven. This is a necessary condition for better appliance
operation and better cooking. Cooling fan shall continue
operation after cooking is finished. Fan shall automatically
stop after cooling is completed. A clearance must be left behind
the enclosure where you'll place the appliance for efficient and
good operation.
This clearance shouldn't be ignored as it's required for
ventilation system of the appliance to operat
46