Connection Via Rs-232C Bluetooth Conversion Adapter - Konica Minolta CS-3000HDR Instruction Manual

Connection via RS-232C Bluetooth Conversion Adapter

By using the commercially-available RS-232C Bluetooth conversion adapter, the instrument can be
connected to a Bluetooth-enabled PC.
Before setting the power switch to ON ( | ), connect an RS-232C Bluetooth conversion adapter (9-pin
D-sub) to the RS-232C connector.
Operating Procedure
1.
Slide power switch to OFF (O).
2.
Connect an RS-232C Bluetooth conversion adapter to the RS-232C
connector.
3.
Make sure that the cable is firmly connected to the RS-232C connector
with the connector's right and left screws.
4.
Enables power supply from the main unit to the RS-232C Bluetooth
conversion adapter.
See Setting RS-232C Power Supply (p.60) for the information on how to enable the power
supply.
For details on settings to communicate with a PC, see the RS-232C Bluetooth conversion
adapter's instruction manual.
Check whether the power supply is applicable to the equipment to be used. Never supply
power to the equipment that does not meet the specifications, as this may cause
malfunctions.
<Power supply>
Output voltage: 5.62 to 6.14 V, Output current: 150 mA max.
84