Vertically Synchronized Signal Input Method - Konica Minolta CS-3000HDR Instruction Manual

Vertically Synchronized Signal Input Method

Vertically synchronized signal is input externally and the frequency is detected by the main unit to
perform external sync measurement.
The vertically synchronized signal output from the measurement object is input to the main unit via a
BNC cable. The input signal must be a CMOS input level (0.8 / 1.2 / 1.8 / 3.3 / 5.0 V, 0.5 to 200 Hz).
Synchronization can be achieved by adjusting the [EXT VOLTAGE] setting on the main unit to the input
signal level.
* Factory default setting: [EXT VOLTAGE] 3.3 V
Operating Procedure
1
1
. Press MENU key when the MEAS screen
is displayed.
The MENU screen appears on the LCD.
When the backlight of the LCD has been turned off via
BACKLIGHT
backlight is turned on.
2
. Press either
[SETUP] and then press ENTER key.
The MENU - SETUP screen appears on the LCD.
5, 6, 7
key on the MEAS screen, the
or key to select
2, 3, 4
M E A S
Lv
x
y
CMF
2˚
MEAS
MEMORY
O P T I O N
S E T U P
D A R K M E A S U R E M E N T
I N F O R M A T I O N
36
8
S N G L U C 0 0 1˚
73. 28 c d
2
m
0 . 3829
0 . 3913
SPD SYN [ Hz ] ACC
Nrm 5 9 . 9 4 Non
M E N U
M E N U
( )
S E T U P 2/3
D A T A F O R M F
R S - 2 3 2 C B A U D R A T E
1 1 5 2 0 0 b p s
E X T V O L T A G E
3 . 3 V
D A T E T I M E
2 0 2 2 / 1 0 / 3 1
1 1 : 0 7 : 3 0