Table of Contents
Advertisement
16 TUNING THE ENGINE
16.7
16.8
118
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
Adjusting the basic position of the shift lever
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Allow the vehicle to run at idle speed.
The malfunction indicator lamp stops flashing once program-
ming is completed.
Info
If the engine becomes too warm, perform a cool-down ride
at medium speed.
After this, do not switch off the engine, but leave it running
at idle speed until the programming is finished.
H02263-10
–
Sit on the vehicle in the riding position and determine distance
between the upper edge of your boot and the shift lever.
Distance between shift lever
and upper edge of boot
»
If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
400692-10
–
1
Remove screw
401950-12
10 ... 20 mm (0.39 ... 0.79 in)
with the washers and take off shift lever
A
(
p. 118)
2
.
Advertisement
Table of Contents
