15.7
Plug-in connector of ignition timing map adjustment
15.8
Changing the ignition timing map
Switching the ignition timing map from Performance to Soft
–
Disconnect plug-in connector
Soft – Better rideability
Switching the ignition timing map from Soft to Performance
–
1
Join plug-in connector
Performance – Higher performance
15.9
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
15.10
Adjusting the basic position of the shift lever
Plug-in connector
on the frame under the fuel tank.
Possible states
Soft – The plug-in connector of the ignition timing map adjustment
•
is disconnected to achieve better rideability.
Performance – The plug-in connector of the ignition timing map
•
adjustment is joined to achieve higher performance.
T01480-10
1
of the ignition timing map adjustment. (Figure T01480-10
of the ignition timing map adjustment. (Figure T01480-10
–
Sit on the vehicle in the riding position and determine distance
between the upper edge of your boot and the shift lever.
Distance between shift lever
and upper edge of boot
»
If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
400692-10
–
Remove screw
401950-12
TUNING THE ENGINE 15
1
of the ignition timing map adjustment is located
p. 99)
10 ... 20 mm (0.39 ... 0.79 in)
1
with the washers and take off shift lever
p. 99)
A
(
p. 99)
2
.
99