GAS GAS MC 450F 2022 Owner's Manual page 86

11 SERVICE WORK ON THE CHASSIS
84
–
Move the hydraulic clutch fluid reservoir mounted on the handlebar
into a horizontal position.
–
Remove screws
–
2
Take off cover
A00825-10
–
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove the protection cap and mount
bleeding syringe
5
screw .
–
Only loosen bleeder screw
ing is possible.
A00893-10
Info
Use water to immediately clean up any brake fluid that has
overflowed or spilled.
Avoid contact between brake fluid and painted parts. Brake
fluid corrodes paint.
Only use clean brake fluid from a sealed container.
–
Now press the fluid into the system until it emerges from hole
of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reservoir to
prevent overflowing.
–
Tighten the bleeder screw and remove the bleeding syringe with the
hose. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
A00826-10
–
Position the cover with the membrane. Mount and tighten the
screws.
1
.
3
with membrane .
4
with the appropriate hydraulic fluid.
p. 144)
4
with an appropriate hose piece on bleeder
5
on the clutch slave cylinder until fill-
4 mm (0.16 in)
6