Checking The Basic Position Of The Shift Lever; Adjusting The Basic Position Of The Shift Lever - GAS GAS MC 250F 2021 Owner's Manual

16 TUNING THE ENGINE
16.6
16.7
106

Checking the basic position of the shift lever

Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.

Adjusting the basic position of the shift lever

–
Sit on the vehicle in the riding position and determine distance
between the upper edge of your boot and the shift lever.
Distance between shift lever
and upper edge of boot
» If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
400692-10
–
1
Remove screw
401950-12
–
Clean gear teeth
–
Mount the shift lever on the shift shaft in the required position and
engage gearing.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any other
vehicle components during the shift procedure.
–
401951-10 Mount and tighten screw
Guideline
Screw, shift lever
10 ... 20 mm (0.39 ... 0.79 in)
with the washers and take off shift lever
A
of the shift lever and shift shaft.
1
with the washers.
M6 14 Nm (10.3 lbf ft)
A
( p. 106)
2
.
Loctite ® 243™