Table of Contents
Advertisement
16 TUNING THE ENGINE
16.4
116
Changing the mapping
Info
The desired engine characteristic can be activated via the MAP button on the combination switch.
The setting most recently selected is activated again when restarting.
The traction control can also be activated in each mapping using the TC button.
The mapping can also be changed during the ride.
–
Remove guide plate
–
Position the required guide plate on the grip tube.
Guideline
The label OUTSIDE must be visible. Marking
tioned at marking
Black guide plate (79002014100)
Alternative 1
Grey guide plate (79002014000)
Info
The gray guide plate opens the throttle valve more slowly.
The black guide plate opens the throttle valve more quickly.
The black guide plate is already mounted when the vehicle is
delivered.
102246-10
–
Clean the outside of the handlebar and the inside of the grip tube.
Mount the grip tube on the handlebar.
–
Attach the throttle cables to the guide plate and route correctly.
–
Position half-shells
Guideline
Screw, throttle grip
–
Slide on sleeve
ment.
A00850-10
Finishing work
–
Check the play in the throttle cable. (
Activating STANDARD mapping:
–
Press button MAP until LED 1 lights up.
Guideline
Engine speed
STANDARD – balanced response
H02889-01
4
5
from handle tube
.
A
B
.
3
, mount and tighten screws
M6
5 Nm (3.7 lbf ft)
1
and check the throttle grip for ease of move-
p. 114)
< 4,000 rpm
must be posi-
2
.
Advertisement
Table of Contents
