17 SERVICE WORK ON THE ENGINE
124
–
Remove screws
G05123-10
–
6
Pull oil filter
Lock ring plier (51012011000)
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surfaces.
S02294-10
–
Lay the motorcycle on its side and fill the oil filter housing to about
⅓ full with engine oil.
–
Place the oil filter into the oil filter housing.
–
Lubricate the O-ring of the oil filter cover and mount it with oil filter
7
cover
.
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
S02295-10
–
Stand the motorcycle upright.
–
Remove filler plug
Engine oil
Info
Too little engine oil or poor-quality engine oil will result in
premature wear of the engine.
–
Mount and tighten the filler plug together with the O-ring.
401955-12
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Start the engine and check it for leaks.
Finishing work
(MC 450F TROY LEE DESIGNS)
–
Install the motor guard. (
–
Check the engine oil level. (
5
. Remove the oil filter cover with the O-ring.
out of the oil filter housing.
M6
10 Nm (7.4 lbf ft)
8
with the O-ring, and fill up with engine oil.
1.2 l (1.3 qt.)
Engine oil (SAE
10W/50) (
p. 52)
p. 121)
p. 144)