GAS GAS MC 450F 2022 Owner's Manual page 82

11 SERVICE WORK ON THE CHASSIS
80
–
Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below the
chain sliding piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain sliding
piece
A00793-10
–
Check the chain guide with a slide gauge for dimension
Minimum thickness
chain guide
» If the measured value is less than the specification:
–
Change the chain guide.
402421-10
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining screws,
chassis
A00792-10
Finishing work
–
Remove the motorcycle from the lift stand. (
M8 15 Nm (11.1 lbf ft)
6 mm (0.24 in)
C
of the
M6 10 Nm (7.4 lbf ft)
p. 49)
C
.