Table of Contents
Advertisement
11 SERVICE WORK ON THE CHASSIS
11.43
11.44
11.45
82
Checking the rubber grips
Adjusting the basic position of the clutch lever
Checking/correcting the fluid level of the hydraulic clutch
Warning
Skin irritation Brake fluid causes skin irritation.
–
Keep brake fluid out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
–
Consult a doctor immediately if brake fluid has been swallowed.
–
Rinse the affected area with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact with the
eyes.
–
If brake fluid spills on to your clothing, change the clothing.
–
Check the rubber grips on the handlebar for damage, wear, and
looseness.
Info
The rubber grips are vulcanized onto a sleeve on the left and
onto the handle tube of the throttle grip on the right. The
left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve or the
throttle tube.
401197-01
»
If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
Check that screw
Guideline
Screw, fixed grip
A
Diamond
A00822-10
–
Adjust the basic position of the clutch lever to your hand size by
turning adjusting screw
Info
Turn the adjusting screw counterclockwise to decrease the
distance between the clutch lever and the handlebar.
Turn the adjusting screw clockwise to increase the distance
between the clutch lever and the handlebar.
The range of adjustment is limited.
Only turn the adjusting screw by hand, and do not use force.
A00795-11
Do not make any adjustments while riding.
1
is firmly seated.
M4
5 Nm (3.7 lbf ft)
must be positioned visibly as shown in the figure.
1
.
Loctite
®
243™
Advertisement
Table of Contents
