Table of Contents
Advertisement
User Guide
EC-C1700B-420
Installation
34 |
©
Danfoss | June 2023
Installation procedure
Risk of electric shock when the connection box lid is open. Make sure that the electric device is
discharged; measure the voltage to make sure of safety.
Heavy electric device. Handle with care. Handle the electric device correctly when you
install it to the correct mounting position. See Chapter
When installing the connection box lid, make sure there are no foreign particles between the
connection box lid and the insulation and that all connection box fasteners are in place.
Missing or loose screws can compromise the insulation.
Do not use excessive force when installing and removing the X1-connector because the
plastic housing of the X1-connector can break. See the Figure below for more information.
Always check the compatibility of the X1-connector and the counterpart. Never alter the
connector in any way.
Handling
on page 28.
BC454142332191en-000101
Advertisement
Table of Contents
