Table 4-24 Flash/File Commands - SMC Networks TigerSwitch SMC8612T2 Management Manual

Command Usage
• This switch provides more efficient throughput for large sequential
data transfers by supporting jumbo frames up to 9216 bytes.
Compared to standard Ethernet frames that run only up to 1.5 KB,
using jumbo frames significantly reduces the per-packet overhead
required to process protocol encapsulation fields.
• To use jumbo frames, both the source and destination end nodes
(such as a computer or server) must support this feature. Also, when
the connection is operating at full duplex, all switches in the network
between the two end nodes must be able to accept the extended frame
size. And for half-duplex connections, all devices in the collision
domain would need to support jumbo frames.
• Enabling jumbo frames will limit the maximum threshold for
broadcast storm control to 64 packets per second. (See the switchport
broadcast command on page -175.)
Example
Console(config)#jumbo frame
Console(config)#
Flash/File Commands
These commands are used to manage the system code or configuration
files.
Command
copy
delete
dir
whichboot
boot system

Table 4-24 Flash/File Commands

Function
Copies a code image or a switch configuration
to or from flash memory or a TFTP server
Deletes a file or code image
Displays a list of files in flash memory
Displays the files booted
Specifies the file or image used to start up the
system
F /F C
LASH ILE OMMANDS
Mode
PE
PE
PE
PE
GC
Page
4-86
4-89
4-90
4-91
4-92
4-85