Mapping Cos Values To Acls; Table 3-13 Egress Queue Priority Mapping - SMC Networks TigerSwitch SMC8612T2 Management Manual

C
ONFIGURING THE

Mapping CoS Values to ACLs

Use the ACL CoS Mapping page to set the output queue for packets
matching an ACL rule as shown in the following table. Note that the
specified CoS value is only used to map the matching packet to an output
queue; it is not written to the packet itself. For information on mapping
the CoS values to output queues, see page 3-166.
Priority
Queue
Command Usage
You must configure an ACL mask before you can map CoS values to the
rule.
Command Attributes
• Port – Port identifier.
• Name
• Type – Type of ACL (IP or MAC).
• CoS Priority – CoS value used for packets matching an IP ACL rule.
(Range: 0-7)
For information on configuring ACLs, see page 3-60.
13.
3-178
S
WITCH

Table 3-13 Egress Queue Priority Mapping

0 1
1 2
13
– Name of ACL.
2 3
0 3
4 5
4 5
6 7
6 7