Signal Connectors - Hantek DSO1000E Series User Manual

5.7 Signal Connectors

See the figure below to find the two signals connectors and a pair of metal electrodes at the
bottom of the oscilloscope panel.
1. CH1, CH2: Input connectors for waveform display, through which to connect and input the
signal to be measured.
2. Probe COMP: Voltage probe compensation output and ground, used to electrically match the
probe to the oscilloscope input circuit. The probe compensation ground and BNC shields
connect to earth ground and are considered to be ground terminals. To avoid damages, do not
connect a voltage source to any of these ground terminals.
DSO1000E Series HandHeld Oscilloscope User Manual
PROBE COMP
Basic Operation
40