Hantek DSO1000E Series User Manual page 44

Trigger Level
Trigger Mode
Trigger Source
Trigger Slope
Trigger Type
Trigger Video Sync
Trigger Video Standard
Vertical Bandwidth
Vertical Coupling
VOLTS
The Autoset function examines all channels for signals and displays corresponding waveforms.
Autoset determines the trigger source according to the following conditions.
➢
If multiply channels get signals, the oscilloscope will use the channel with the lowest
frequency signal as the trigger source.
➢
If no signals are found, the oscilloscope will use the lowest-numbered channel displayed
in Autoset as the trigger source.
➢
If no signals are found and no channels are displayed, the oscilloscope will display and
use Channel 1 as the trigger source.
Sine Wave:
When you use the Autoset function and the oscilloscope determines that the signal is similar to a
sine wave, the oscilloscope displays the following options.
Sine Wave Options
Multi-cycle Sine
Single-cycle Sine
Cancel
Square Wave or Pulse:
When you use the Autoset function and the oscilloscope determines that the signal is similar to a
square wave or pulse, the oscilloscope displays the following options.
Square Wave Options
Multi-cycle
Single-cycle
Rising
Falling
Cancel
DSO1000E Series HandHeld Oscilloscope User Manual
Set to 50%
Auto
Adjusted
Adjusted
Edge
Adjusted
Adjusted
Full
DC (if GND was chosen before); AC for the video signal; otherwise,
unchanged
Adjusted
Display multiple cycles that have appropriate vertical and
horizontal scales.
Set the horizontal scale to display about one cycle of the
waveform.
Let the oscilloscope recall the previous setup.
Display multiple cycles that have appropriate vertical and
horizontal scales.
Set the horizontal scale to display about one cycle of the
waveform. The oscilloscope displays Min, Mean and Positive
Width automatic measurements.
Display the rising edge.
Display the falling edge.
Let the oscilloscope recall the previous setup.
Details
Details
Basic Operation
39