Display - Hantek DSO1000E Series User Manual

Self Cal: The self calibration routine can optimize the precision of the oscilloscope to fit the
ambient temperature. To maximize the precision, you should perform the self calibration once the
ambient temperature changes by 5℃ or more. Follow the instructions on the screen.
Tip: Press any menu button on the front panel to remove the status display and enter a
corresponding menu.

5.5.4 DISPLAY

The waveform display is affected by settings of the oscilloscope. A waveform can be measured
once it is captured. The different styles to display a waveform on the screen give significant
information about it.
There are two modes to display waveforms Single-window and Dual-window. Refer to Horizontal
Controls for more information.
The DISPLAY menu.
Options
Vectors
Type
Dots
OFF
Persistency 0.2S-8S selectable
Infinite
YT
DSO Mode
XY
Contrast
Dotted line
Grid Real line
OFF
Grid Intensity
Auto
50 Frames
Refresh Rate
40 Frames
30 Frames
Wave Bright
BL Keep 5s,10,30s,60s,Unlimited
Menu Keep 5s,10,30s,60s,Unlimited
DSO1000E Series HandHeld Oscilloscope User Manual
Settings
Vectors fills up the space between adjacent sample
points in the display; Dots only displays the sample
points.
Sets the time length to display each displayed
sample point.
YT format shows the vertical voltage in relation to
time (horizontal scale); XY format displays a dot
between CH1 and CH2 each time when a sample is
acquired, where the voltage or current of CH1
determines the X coordinate of the dot (horizontal)
and the voltage or current of CH2 determines the Y
coordinate (vertical). For detailed information, refer
to descriptions on XY format in the following text.
0-15 16 ranks adjustable.
Off only displays the horizontal and vertical
coordinates at the center graticule on the screen.
0-15 16 ranks adjustable.
0-15 16 ranks adjustable.
Basic Operation
Comments
35