Safety Instructions For The Personnel; Personal Safety Equipment; Safe Handling Of Wagner Powder Spray Devices - WAGNER IP 5000 Translation Of The Original Operating Manual

EDITION 08/2021
4.2

SAFETY INSTRUCTIONS FOR THE PERSONNEL

Always observe the information in this manual, particularly the safety instructions
and the warning instructions.
Always follow existing regulations concerning occupational safety and accident
prevention regulations.
In electrostatics applications: Persons belonging to a risk group according to
EMF guideline 2013/35/EU (e.g., carriers of active implants), must not enter the
high-voltage area.

4.2.1 PERSONAL SAFETY EQUIPMENT

Danger due to dust formation!
Serious or fatal injuries due to inhalation, swallowing or contact with the skin or eyes.
Observe the processing regulations laid down by the manufacturer of the powder
lacquer being used, when preparing or processing the powder.
Take note of the manufacturer's notification and the relevant environmental
protection regulations when disposing of powder lacquers.
Take the specified protective measures. In particular, wear safety goggles, protective
clothing and gloves, as well as hand protection cream if necessary.
Use a mask or breathing apparatus if necessary.
For sufficient health and environmental protection, only operate the device with
technical ventilation (extraction) switched on.

4.2.2 SAFE HANDLING OF WAGNER POWDER SPRAY DEVICES

Danger due to dust formation!
Do not point spray guns at people.
Do not spray device parts using electrostatic equipment.
Before any work on the device, in the event of work interruptions and malfunctions:
– Switch off the energy/compressed air supply.
– Relieve pressure on powder spray gun and device.
– Secure the powder spray gun against actuation.
– Disconnect the control unit from the mains.
– In the event of functional faults: remedy the fault as described in the
"Troubleshooting" chapter.
Carry out the work steps in accordance with the chapter on pressure relief in the
operating manual of the corresponding device:
– if pressure relief is required,
– if the coating work is interrupted or stopped,
– before the device is cleaned on the outside, checked, or serviced,
– before the spray nozzle is installed or cleaned.
ORDER NUMBER DOC241936
IP 5000
13