Danfoss VLT AQUA Drive FC 200 Instruction Manual page 76
Low harmonic drive
Hide thumbs
Also See for VLT AQUA Drive FC 200:
- Programming manual (282 pages) ,
- Operating instructions manual (185 pages) ,
- Instruction manual (157 pages)
Table of Contents
Advertisement
VLT AQUA Low Harmonic Drive Instruction
Manual
Input polarity of control terminals
NOTE!
To comply with EMC emission specifications, shielded/armored cables are recommended. If a non-shielded/unarmored cable is used,
see section
Power and Control Wiring for Non-shielded cables
cores to improve EMC performance.
Connect the wires as described in the Instruction Manual for the adjustable frequency drive. Remember to connect the shields in a proper way to ensure
optimum electrical immunity.
. If non-shielded control cables are used, it is recommended to use ferrite
®
MG.20.T1.22 - VLT
is a registered Danfoss trademark
4 How to Install
4
4-59
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT AQUA Drive FC 200 and is the answer not in the manual?
Questions and answers