Danfoss VLT AQUA Drive FC 200 Instruction Manual page 107

6 How to Program the Low Harmonic Drive
0-71 Date Format
Option:
[0] * YYYY-MM-DD
[1] DD-MM-YYYY
[2] MM/DD/YYYY
0-72 Time Format
Option:
[0] * 24 h
[1] 12 h
0-74 DST/Summertime
Option:
6
[0] * OFF
[2] Manual
0-76 DST/Summertime Start
Range:
Application [Application dependant]
dependent*
0-77 DST/Summertime End
Range:
Application [Application dependant]
dependent*
6.3.3 General Settings, 1-0*
Define whether the adjustable frequency drive operates in open-loop or closed-loop.
1-00 Configuration Mode
Option:
[0] * Open-loop
[3] Closed-loop
6-14
Function:
Sets the date format to be used in the LCP.
Sets the date format to be used in the LCP.
Sets the date format to be used in the LCP.
Function:
Sets the time format to be used in the LCP.
Function:
Choose how Daylight Saving Time/Summertime should be handled. For manual DST/Summertime
enter the start date and end date in par. 0-76
time End
.
Function:
Sets the date and time when summertime/DST starts. The date is programmed in the format se-
lected in par. 0-71 Date Format .
Function:
Sets the date and time when summertime/DST ends. The date is programmed in the format selected
Date Format
in par. 0-71 .
Function:
Motor speed is determined by applying a speed reference or by setting desired speed when in Hand
Mode.
Open-loop is also used if the adjustable frequency drive is part of a closed-loop control system based
on an external PID controller providing a speed reference signal as output.
Motor speed will be determined by a reference from the built-in PID controller varying the motor
speed as part of a closed-loop control process (e.g., constant pressure or flow). The PID controller
must be configured in par. 20-** or via the function set-ups accessed by pressing the [Quick Menu]
button.
®
MG.20.T1.22 - VLT is a registered Danfoss trademark
VLT AQUA Low Harmonic Drive Instruction
DST/Summertime Start
and par. 0-77
Manual
DST/Summer-