Danfoss VLT AQUA Drive FC 200 Instruction Manual page 138

VLT AQUA Low Harmonic Drive Instruction
Manual
23-02 OFF Time
Array [10]
Range:
Application [Application dependant]
dependent*
23-03 OFF Action
Array [10]
Option:
[0] * DISABLED
[1] * No action
[2] Select set-up 1
[3] Select set-up 2
[4] Select set-up 3
[5] Select set-up 4
[10] Select preset ref 0
[11] Select preset ref 1
[12] Select preset ref 2
[13] Select preset ref 3
[14] Select preset ref 4
[15] Select preset ref 5
[16] Select preset ref 6
[17] Select preset ref 7
[18] Select ramp 1
[19] Select ramp 2
[22] Run
[23] Run reverse
[24] Stop
[26] Dcstop
[27] Coast
[32] Set digital out A low
[33] Set digital out B low
[34] Set digital out C low
[35] Set digital out D low
[36] Set digital out E low
[37] Set digital out F low
[38] Set digital out A high
Function:
Sets the OFF time for the timed action.
NOTE!
The adjustable frequency drive has no backup of the clock function and the set
date/time will reset to default (2000-01-01 00:00) after a power-down unless a
real time clock module with backup is installed. In par. 0-79
possible to program for a warning in case the clock has not been set properly,
e.g., after a power-down.
Function:
Select the action during OFF Time. See par. 13-52
tions.
®
MG.20.T1.22 - VLT is a registered Danfoss trademark
6 How to Program the Low Harmonic Drive
SL Controller Action
for descriptions of the op-
Clock Fault
, it is
6
6-45