Advertisement
(3)
Install the dust wiper to the gland using a special
installing tool. Coat the dust wiper with grease
slightly before installing.
(4)
Using a special tool, install gland assembly into
the cylinder tube.
(5)
Using a hook spanner, install the gland ass-
embly, and tighten it with torque 60±6kgf·m
(434±43lbf·ft).
(6)
After the gland assembly was installed to the
cylinder tube, calk at the tube end into the
groove on the gland to prevent screw loosen-ing.
※
If it is needed to calk again, never calk on the
same place.
(7)
Move the piston rod back and forth several times for the full distance of its stroke. This helps to
seat the ring and seals before applying full hydraulic pressure to the cylinder.
(8)
Install cylinder into trail axle.
(9)
While idling the engine with the rear wheels off the ground, operate the steering wheel left and
right alternately.
※
Then, repeat the above operation at gradually increasing engine rpm. This releases air from the
system and completes preparation for operation.
(10)
Stop the engine, lower the floating rear wheels, and check pump joints for oil leaks and looseness
and retighten, them as required.
5-32
D353SE29
D353SE30
D353SE31
Advertisement
