(
(
4)
Installation of the external and internal
rotor
※
Install the external rotor.
Chamfer shows to the pump base
(cannot be seen in the picture).
※
Install the internal rotor.
Gearing(arrow) shows downwards.
①
Put on the cam disc and by means of two
cap screws(1) fasten it radially.
※
Do not tighten the cap screws - just turn
then in until contact is obtained and then
make approx. 1/2 rotation back.
Observe the installation position of the
cam disc.
Put the O-ring(2) into the annular groove
and oil it.
②
Mount the preassembled pressure oil
pump(1) and with the cap screws(3pcs.)
first place it equally until contact is
obtained.
※
Observe the radial installation position.
Then remove the cap screws again.
1
3-102
D507TM194
2
D507TM195
1
D507TM196