⑦
Remove drive(8).
⑧
Remove spacer plate(7).
⑨
Replace O-ring(24) in housing(10).
※
Be careful that O-ring size(23) and (24) is
different.
⑩
Put spacer plate(7) on housing(10).
Align bolt holes in spacer plate(7) with
tapped holes in housing(10).
※
Pich dia. of bolt holes and oil holes in
spacer plate(7) is different.(Larger pitch
dia. is for bolt holes).
⑪
Install drive(8) and engage with pin(13).
⑫
Mark drive(8) spline end parallel to
pin(13) to make sure relationship of drive
(8) and pin(13). Refer right figure 6 line B
and line C.
⑬
Align star valleys(right figure line A) with
marked drive(8)(right figure line B). Star
valleys must align with pin(13). Note
parallel relationship of lines A, B and C in
right figure.
Make sure relationship of parts.
If relationship is mistaken, it is
possible to cause big trouble for
steering.
Gerotor star valley
Drive
(Marked)
Pin
5-26
24
7
8
100D7SS14
24
100D7SS15
A
B
C
100D7SS16
D