Advertisement
⑮
Remove the pipes(system pressure from
the electro-hydraulic control to the
respective clutch).
Remove the holding segment(6).
The pipes are to disassembled in the
following sequence:
1 = Pipe
2 = Pipe
3 = Pipe
4 = Pipe
5 = Pipe
Remove all bearing outer rings(see
arrows).
※
Should contrary to the recommen-
dations the taper roller bearings of the
clutches as well as of the input not be
replaced the assignment(bearing inner
and outer ring) has to be kept at least.
Mark the bearing inner and bearing outer
rings to each other accordingly.
3
5
k3
k1
k2
kR
kV
3-66
4
1
2
6
D507TM45
D507TM46
Advertisement
