Advertisement
(
(
2)
BASIC SETTING REGULATION
①
Turn the adjusting screw manually clockwise until both brake pads make contact with the brake
disk. Then it is not longer possible to turn the adjusting screw without exerting a major amount of
force.
②
Turn the adjusting screw anticlockwise in order to set the following rated clearances.
Model
110D/130D/
140D/160D-7E
③
Hold the adjusting screw in position with a hexagonal socket wrench and lock with lock nut.
④
Mount the screw cap and tighten as far as possible manually.
Mount the pressure connection in accordance with the instructions of the axle.
¤º
※
For bleeding the piston chamber use the socket spanner size 13 for the bleeding valve.
(
(
3)
ADJUSTING REGULATIONS
During this adjusting process, the parking brake must be released, i.e. the bank of cup springs
must be completely pre-tensioned.
①
Stand the vehicle on an even surface and secure against rolling away.
②
Release the parking brake by using the required release pressure.
③
Release the screw cap and unscrew.
④
Release the lock nut(size 24 or 30) and turn the adjusting screw with socket wrench size 8 or 10
manually clockwise until the two brake pads make contact with the brake disk.
Turn the adjusting screw anti-clockwise and set the clearance specified in the above table.
¤º
Hold the adjusting screw in position with the hexagonal socket wrench and lock with the lock nut.
¤
Mount the screw cap and tighten as far as possible manually.
¤
※
Actuate the brake valve several times and check the braking efficiency of the parking brake on a
slope.
Adjusting screw
M16(SW 8)
Clearance(mm)
Clearance
4-14
Turns
Min.
0.5
1/4
1.0
1/2
Max.
1.5
3/4
Advertisement
