Advertisement
2)
GENERAL INSTRUCTION
(1)
Always work in a clean environment.
(2)
Wash all components in solvent and blow dry with compressed air before refitting.
(3)
Take care not to damage rubber seals.
(4)
Avoid damaging precision machined surfaces.
(5)
Components should fit into their housings without excessive force. If force is necessary, this
normally means that the component does not have the correct dimensional tolerances of is
aligned incorrectly.
(6)
When hand pressure is insufficient, only use presses or rubber hammer to fit components.
(7)
Never strike components with steel hammers.
(8)
Steel bush must be fitted only with a suitable press.
(9)
Do not use hammers to fit bearings.
(10)
Always respect the direction of rotation when assembling components.
3)
DISASSEMBLY
Mounting flange
(1)
①
Loosen and remove the assembling bolts
and washers from the pump.
②
Remove the snap-ring(1) with proper
tool(only when it is needed to replaces
shaft seal).
③
Remove the shaft seals(2) taking care
not to give any damage on the surface of
shaft hole(only when it is needed to
replae shaft seal).
※
Replace the shaft seal if damaged.
1
2
4-44
110D7EBS10
110D7EBS11
Advertisement
