Advertisement
1
1
0)
ASSEMBLY OF PLANETARY GEAR DRIVE
(1)
Prepare the ring gear and the ring gear
carrier
Heat the taper roller bearing inner ring
with cage(1) to about 100。 C and install it
onto the ring gear carrier(2). Place the
ring gear(3) onto the ring gear carrier.
Bolt the retainer(5) with the screws(4),
secure the screws with Loctite 270.
(2)
Assembly of the ring gear carrier
Install the ring gear carrier(2) with ring
gear(3) into the wheel hub respective onto
the steering knuckle respective axle
spindle.
The oil compensating hole in the ring gear
carrier must be on the bottom.
Subsequent adjust wheel bearings(see
page 132).
(3)
Assembly of the thrust ring
Press the thrust ring(6) into the steering
knuckle respective axle spindle. Secure
with Loctite 270.
(4)
Assembly of the sun gear
Slip the sun gear(7) onto the universal
joint respective axle shaft, install the
circlip(9) and push the universal joint
respective axle shaft towards the inside
until the circlip contacts to the sun gear
and the sun gear contacts to the thrust
ring.
3-138
100D7XL60
100D7XL61
100D7XL62
Advertisement
