Install The External Emc Noise Filter - YASKAWA FP605 Installation & Primary Operation

A - SW (ON)
If you lose an EMC filter switch screw, use
screws with the correct tightening torque.
NOTICE
Only use the screws specified in this manual. If you use screws that are not approved, it can cause damage to the
drive.
Model
2011 - 2059, 4005 - 4065
2075 - 2114, 4077 - 4124
2143, 2169, 4156
■

Install the External EMC Noise Filter

Drive models 2xxxA and 4xxxA must meet conditions in this section to comply with IEC/EN 61800-3.
Connect an EMC noise filter that complies with European standards as specified by Yaskawa to the input side
External EMC Noise Filter Selection on page 102
(primary side). Refer to
Use this procedure to install an EMC noise filter to make equipment and devices added to the drive comply with the
EMC Directive.
1.
Install the drive and EMC noise filter on the same grounded metal plate.
2.
Wire the drive and motor.
3.
Ground the wire shielding on the drive side and motor side.
A - Drive
B - 10 m (32.8 ft) maximum
C - Motor
YASKAWA TOEPC7106171FD FP605 DRIVE INSTALLATION & PRIMARY OPERATION
B - Screw (OFF)
Figure 13.11 EMC Filter Switch Location 5
Table 13.8 to find the correct replacement screw and install the new
Table 13.8 Screw Sizes and Tightening Torques
Screw Size
M4 × 20
M4 × 30
M5 × 25
D - Metal conduit
E - Grounding wire
Figure 13.12 Wiring the Drive and Motor
13 European Standards
Tightening Torque
N∙m
1.0 - 1.3
1.0 - 1.3
2.0 - 2.5
to select the correct EMC noise filter.
99