Table of Contents
Advertisement
6 Mechanical Installation
Remove the Front Cover
1.
Remove the keypad from the drive.
A - Keypad
2.
Loosen the front cover screw.
3.
Push on the tabs in the sides of the front cover then pull the front cover forward to remove it from the drive.
Reattach the Front Cover
1.
Wire the drive and other peripheral devices.
2.
Reverse the steps to reattach the cover.
Note:
• Make sure that you did not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
• Make sure that the tabs on the sides of the front cover correctly click into the hook.
• Tighten the screws to a tightening torque of 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in).
20
Figure 6.8 Remove the Keypad
Figure 6.9 Loosen the Front Cover Screw
Figure 6.10 Remove the Front Cover
YASKAWA TOEPC7106171FD FP605 DRIVE INSTALLATION & PRIMARY OPERATION
Advertisement
Table of Contents
