Settings For Turbidity Measurement - Xylem WTW Turb 750 IR Operating Manual

®
Turb 750 IR/T
Overview
Settings/functions
ba77233e05 06/2023

4.8.1 Settings for turbidity measurement

For turbidity measurements, the following settings are possible in the menu
Configuration / Turbidity:
 Calibration
 AQA
 Resolution
 Reset
The settings are in the menu, Configuration / Turbidity.
Move to the Configuration menu with the <MENU
Menu item Setting
...
Calibration
-
Calibr. record
...
AQA
-
AQA protocol
0.01
Resolution
0.001
Unit for turbidity FNU/NTU
(only for
EBC
®
Turb 750 IR)
-
Reset
(7)
> key.
Explanation
Settings and data in the menu Calibra-
tion (see section 4.9.1).
The menu item is displayed if the autho-
rization exists (see section 4.2).
Display the calibration record of the last
calibration.
The menu item is displayed if there is no
authorization for the Calibration menu
(see section 4.2).
Functions and settings for analytical
quality assurance (see section 4.10).
The menu item is displayed if the autho-
rization exists (see section 4.2).
Displays the AQA protocol of the last
check.
The menu item is displayed if there is no
authorization for the AQA menu (see
section 4.2).
Resolution of the FNU/NTU display for
the range 0.01... 0.99 FNU/NTU
Unit of the measured turbidity values
Reset all settings for the Turbidity mea-
suring mode (see section 4.13.2).
The menu item is displayed if the autho-
rization exists (see section 4.2).
Operation
33