Orp Measurement Settings; Settings For Orp Measurements; Measurement Settings; Settings For D.o. Sensors (Menu For Measurement And Calibration Settings) - Xylem YSI MultiLab 4010P-1 Operation Manual

MultiLab 4010-1
Settings
ba76141e03 03/2014
3. Confirm the setting with <MENU/ENTER>.
4. Quit the menu with <M>.
9.2

ORP measurement settings

9.2.1 Settings for ORP measurements

The settings are made in the menu for measuring settings of the ORP measure-
ment. To open the settings, display the required measured parameter in the
measured value display and press the <MENU/ENTER> key. After completing
the settings, switch to the measured value display with <M>.
Default settings are printed in bold.
Menu item
mV resolution
Reset
9.3 D.O. measurement settings
9.3.1 Settings for D.O. sensors
(menu for measurement and calibration settings)
The settings are available in the menu for measurement and calibration set-
tings. To open the settings, display the required measured parameter in the
measured value display and press the <MENU/ENTER> key. After completing
the settings, switch to the measured value display with <M>.
Default settings are printed in bold.
Menu item
Calibration /Cali-
bration record
Calibration / Cali-
bration data stor-
age / Display
Calibration /
Calibration data
storage / Output
to RS232/USB
Possible setting
0.1
1
-
Possible Description
setting
- Displays the calibration record of the
last calibration.
- Displays the last calibration records
(max. 10)
- Outputs the calibration data storage to
the interface
Description
Resolution of the mV display
Resets all sensor settings to the
delivery condition (see section
9.6.1 R
ESETTING THE MEASURE
, page 70).
MENT SETTINGS
Settings
-
63