Table of Contents
Advertisement
®
Turb
750 IR/T
ba77233e05
06/2023
9
Firmware update
You can find available firmware update files for your meter on the Internet.
With the "Firmware Update " program and a PC you can update the firmware
®
of the Turb
750 IR/T to the newest version.
For the update you have to connect the meter to a PC.
For the update via the USB-B interface, the following is required:
a free USB interface (virtual COM port) on the PC
the driver for the USB interface (on the enclosed CD-ROM)
the USB cable (included in the scope of delivery of the Turb
1
Install the downloaded firmware update on a PC.
An update folder is created in the Windows start menu.
If an update folder already exists for the meter (or meter type), the new
data are displayed there.
2
In the windows start menu, open the update folder and start the firm-
ware update program for the meter
3
Using the USB interface cable, connect the Turb
interface (virtual COM port) of the PC.
4
Switch on the Turb
5
In the firmware update program, start the update process with OK.
6
Follow the instructions of the firmware update program.
During the programming process, a corresponding message and a
progress bar (in %) are displayed.
The programming process takes up to 15 minutes. A terminatory mes-
sage is displayed after a successful programming process. The firm-
ware update is completed.
7
Disconnect the Turb
®
The Turb
750 IR/T is ready for operation again.
After switching the meter off and on you can check whether the meter has
taken over the new software version (menu Configuration System Info).
®
750 IR/T.
®
750 IR/T from the PC.
Firmware update
®
750 IR/T).
®
750 IR/T to a USB
67
Advertisement
Table of Contents
