Connecting The Power Pack; Initial Commissioning - Xylem WTW Turb 750 IR Operating Manual

Commissioning
12
2. Place four batteries (type Mignon AA) in the battery compartment.
NOTE
Make sure that the poles of the batteries are positioned correctly.
The ± signs on the batteries must correspond to the
tery compartment.
3. Close the battery compartment (1).
4. Set the date and time
(see section 4.5.5).
3.2.2

Connecting the power pack

WARNING
The line voltage at the operating site must lie within the input
voltage range of the original power pack (see chapter
7 T
ECHNICAL DATA
Use original power packs only (see chapter 7 T
).
TA
1 If necessary, replace the Euro plug of the power pack with the coun-
try-specific plug suitable for your country.
2 Insert the plug of the power pack into the socket of the turbidimeter.
3 Connect the power pack unit to an easily accessible mains socket.
3.3

Initial commissioning

Perform the following activities:
 Insert the batteries (see section 3.2.1)
 Connect the power pack (see section 3.2.2)
 Set the language as necessary (see section 4.6.3)
 Set the date and time as necessary (see section 4.6.4)
When you set the language, date and time according to the men-
tioned sections of this operating manual you will quickly become
familiar with the simple operation of the Turb
).
®
Turb 750 IR/T
±
signs in the bat-
-
ECHNICAL DA
®
750 IR/T.
ba77233e05 06/2023