Table of Contents
Advertisement
Operation
Preparing the
calibration
Carrying out a cali-
bration (example:
3-P StdCAL)
38
CAL#1 30.0
1234abcd_
6
Confirm the entered character string with <START/ENTER
The lot number is assigned to the standard.
7
Enter the lot numbers for all further standards.
8
Exit the menu with <ESC> or <MENU
4.9.3 Carrying out a calibration
For quick and easy measuring we recommend that you use marked cells with
the calibration standards (see section 4.5.1 P
If your cells are not marked you can determine the suitable position of the in-
dividual cells in the cell shaft while measuring.
Perform the following preparatory activities when you want to calibrate:
1
Select the calibration type (menu Configuration / Turbidity / Calibr.
type.).
For QuickCAL calibration with the <QuickCAL
setting of the QuickCAL calibration type and limitation of
the measuring range are done automatically.
2
Clean the cell (see section 5.2.2).
3
Insert the cell (see section 4.4).
4
Press the <CAL
The guided calibration with the selected calibration type starts.
Follow the instructions on the display.
[A-Z]
(4)
> key.
Turb
(7)
>.
).
REPARING THE CELL
(1)
ba77233e05
®
750 IR/T
(.)
>
> key, the
06/2023
Advertisement
Table of Contents
