QOLSYS IQ4 Hub Installation Manual page 49

PROGRAMMING
SOUND
Setting Default
Trouble Beeps** Disabled
PowerG Siren Trouble
Disabled
Beeps
Sensor Low Battery** Disabled
Sensor Tamper
Disabled
Beeps**
Panel Tamper Beeps** Disabled
Edit Trouble Beep
Chimes
Trouble Beeps
Timeout***
Fire and Life Safety
Enabled
Device Trouble Beeps
Trouble Beeps
Toggles all sensor and panel trouble beeps on or off. By default all
trouble beeps are disabled
Determines whether PowerG sirens sound trouble beeps (enabled)
or not (disabled)
Panel sounds when a sensor battery is low. Chime type and
frequency are set below. By default these sounds are disabled
Panel sounds when a sensor is tampered. Chime type and frequency
are set below. By default these sounds are disabled
Panel sounds when tampered or opened. Chime type and frequency
are set below. By default these sounds are disabled
Select the chime type for Sensor Low Battery, Sensor Tamper, and
n/a
Panel Tamper
Determines the amount of time between each trouble beep. Length
30
can be set between 3-60 mins. (default is 30 mins)
Panel will sound a trouble alert if a fire safety device is tampered,
failed or has a low battery (disabled by default)
Description
FIND IT
Swipe down
for access
SETTINGS
ADVANCED SETTINGS
ENTER CODE (1111, 2222)
SOUND
**Set to Enabled for EN Grade 2
installations.
*** Setting shall be set to 3 min for
EN Grade 2 installations