Table of Contents
Advertisement
PROGRAMMING
SECURITY AND ARMING
Setting
Screen Lock
Secure Arming
Force Arm
Refuse Arming When Battery
Low
Auto Bypass
Final Exit Door Arming
Auto Stay
Default
When enabled, a screen lock page will appear. Screen lock restricts access to the panel based
Disabled
on valid user codes.
subsequently be disabled if desired. It is also enabled for "EN Grade 2"
Disabled
Require user code for arming the panel.
If a device has been Auto Bypassed during the arming sequence, and then subsequently
Disabled
restored (closed), either during the exit delay or after the system has already been armed, it
will be un-bypassed and re-included in the protected area.
Disabled
Will not allow panel to arm if battery is low (below 8%).
Toggle whether or not to bypass open or tampered sensors automatically.
Enabled
for UL/cUL. This setting is turned off and greyed out when the "En Grade 2" setting is enabled.
When enabled, if Arm Away is selected at the panel then there is no timed exit delay. Instead,
Disabled
the system is not fully armed until an Entry/Exit door is violated.
unavailable unless EN Grade 2 is enabled.
If panel is armed "Away" but a delay door is not opened, the panel assumes you are still home
Enabled
and changes arming to "Stay" mode
QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE
Description
NOTE: This setting is automatically enabled when Partitions are enabled, though it can
NOTE: this option shall be enabled for UL/cUL and EN Grade 2
43
OF
197
NOTE: This option shall be enabled for EN Grade 2
NOTE: Shall be disabled
NOTE: This setting is greyed out an
Advertisement
Table of Contents
