Install Build Plate - TierTime UP mini 3 User Manual

3. Turning the upper cover of the air filter clockwise to close it.
Note: Change the air filter every 3 months, or every 300 hours of active printing.

3.3 Install Build Plate

Place the print board in the slots of the platform with the side of the perf board facing up, push the board
forward and make sure the board fits in the slot.
If printing with no raft, make sure the glass side of the print board facing upward, and then apply glue or tapes
on the surface of the print board.
Note: Print board has two surfaces. One side is perf board and the other side is glass board, both of which can be
a print plate. The perf board side is suitable to print with raft, and it can be used to print the materials that are
easy to warp, e.g. ABS. If printing with no raft, use the glass side of the board with glue or tapes on the surface.
7