Table of Contents
Advertisement
5, A clean and straight stream of melted filament
should be extruded from the tip of the nozzle.
5.2.2 Install Filament (UP Studio software)
Besides installing filament through the touchscreen interface, you can also do it using UP Studio software.
1, Same as the instruction above, insert the
filament to the inlet on the top of the extruder.
2, Open the UP Studio software, and click the
"Maintenance" button on the left menu. First,
choose the filament type, say "PLA (Tiertime)", then
enter the filament weight for the system to record
the filament usage.
3, Click the "Extrude" button, the nozzle will start
heating up. When the temperature reaches the
preset value, the print will give off a beep. Insert
the filament into the inlet on the top of the
extruder. Press the filament, until the extruder
motor grabs the filament and pulls it in.
24
Advertisement
Table of Contents
Need help?
Do you have a question about the UP mini 3 and is the answer not in the manual?
Questions and answers