Table of Contents
Advertisement
Using the Network Setting menu
Use the Network setting menu to configure network-related settings for the C620. For more
information about these settings, see
Network Settings" on page
To use the Network setting menu:
1. From the Admin Settings menu, press
then press
2. Press
The IPv4 or IPv6 menu appears.
To enable or disable DHCP:
1. From the IPv4 or IPv6 menu, with Mode highlighted, press
The IP Type screen appears.
2. Press
then press
For IPv4, DHCP is enabled by default, which means the C620 will get its IP address from
the network. When DHCP is disabled, you must enter a static IP address for the C620.
For IPv6, DHCP is disabled by default.
Configuration Using the Phone Menus
69.
.
to highlight IPv4 or IPv6, and then press
or
to select DHCP (for IPv4), Auto (for IPv6), Static IP, or Disabled, and
or
.
C620 Administrator and Provisioning Manual
"Basic Network Settings" on page 67
to highlight Network setting, and
or
25
and
"Advanced
.
.
Back to Contents
Advertisement
Table of Contents
