Network Pages - Snom C620 Administrator And Provisioning Manual

Network Pages

You can set up the C620 for your network configuration on the Network pages. Your service
provider may require you to configure your network to be compatible with its service, and
the C620 settings must match the network settings.
The network settings are grouped into Basic and Advanced Settings. IPv4 and IPv6
protocols are supported.
When both IPv4 and IPv6 are enabled and available, the following guidelines apply when
determining which stack to use:
For outgoing traffic, the IP address (or resolved IP) in the server field—either IPv4

or IPv6—will determine which stack to be used.
In general, most operations can be associated with one of the servers listed on the

"Basic Network Settings" page. However, for operations triggered by/dependent
upon network status, the phone must determine which server to use. For example,
a special case like the "Network down" LED indication on the base station can be
ambiguous for server association. Because its primary purpose is to aid in
troubleshooting SIP registration issues, this case will be associated with the SIP
registration server.
DNS entries with both IPv4 and IPv6 settings can be used to resolve FQDN entries.

There are no preferences with the order of the DNS queries.
Pcap should include traffic for both stacks.

Dual stack operations should be transparent to PC port traffic.



The network settings are also available as parameters in the configuration file. See
""network" Module: Network Settings" on page
After entering information on this page, click
Using the WebUI
PnP is not supported on IPv6.
VPN is not supported in IPv6 or PPPoE.
66
C620 Administrator and Provisioning Manual
140.
to save it.
Back to Contents