Identification Of Drive Shafts - PRONAR T679/4M User Manual

General

1.2 IDENTIFICATION OF DRIVE SHAFTS

3
5
3
5
Figure 1.2 Location of the nameplate.
(1) control arm front and rear (2) control arm front
(3) braked shaft
(4) unbraked drive shaft (5) axle plate
Axis serial number 1
Axis serial number 2
4
2
3
1
609-E.02-1
The drive shaft serial number and type is
stamped on the type plate (5) attached to
the axle shaft cover. Two shafts connected
permanently by a beam form a suspension
swingarm. Control arm braked on both
sides (1) and control arm braked with front
half axle (2) - figure (1.2).
ADVICE
If you need to order spare parts or if you have prob-
lems with it, it is very often necessary to provide the
serial numbers of the trailer or axle, so it is recom-
mended to write these numbers in the fields below.
PRONAR T679/4M
Chapter 1
E.3.2.609.01.2.EN
1.3