Section 1: To The Installer; Installer Safety; Site Preparation; Electrical Connections - Taylor 811 Series Operator's Manual

Section 1
The following information has been included in the
manual as safety and regulatory guidelines. For complete
installation instructions, please see the Installation
Checklist.

Installer Safety

IMPORTANT! In all areas of the world,
machines should be installed in accordance with existing
local codes. Please contact your local authorities if you
have any questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and service
®
of Taylor machines.
• Only Taylor service personnel should perform
installation, maintenance, and repairs on Taylor
machines.
• Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for industry
standards on lockout/tagout procedures before
beginning any installation or repairs.
• Authorized service personnel must ensure that
the proper personal protective equipment (PPE)
is available and worn when required during
installation and service.
• Authorized service personnel must remove all
metal jewelry, rings, and watches before
working on electrical equipment.
DANGER! The main power supply(s) to the
freezer must be disconnected prior to performing any
repairs. Failure to follow this instruction may result in
personal injury or death from electrical shock or
hazardous moving parts as well as poor performance or
damage to the machine.
Note: All repairs must be performed by a Taylor service
technician.
To the Installer
WARNING! This machine has many sharp
edges that can cause severe injuries.

Site Preparation

Review the area where the machine will be installed
before uncrating the machine. Make sure all possible
hazards to the user or equipment have been addressed.
Fill out the store survey form.
location where its use and maintenance is restricted to
trained personnel. Failure to comply may result in
personal injury.

Electrical Connections

The grill is supplied with one power cord. Check the data
plate on the grill for voltage, cycle, phase, and electrical
specifications.
For proper power connections, refer to the wiring
diagram provided inside the left-side panel, attached to
the gas manifold assembly. The power connection is
located behind the access line cover on the front of the
grill.
In the United States, this equipment is intended to be
installed in accordance with the National Electrical Code
(NEC), ANSI/NFPA 70-1987. The purpose of the NEC
code is the practical safeguarding of persons and
property from hazards arising from the use of electricity.
This code contains provisions considered necessary for
safety. Compliance therewith and proper maintenance
will result in an installation essentially free from hazard!
In all other areas of the world, equipment should be
installed in accordance with the existing local codes.
Please contact your local authorities.
The proper wire size and branch circuit overcurrent
device shall be selected according to the data label
information and in accordance with CEC Part I 2006,
Section 14-100(e)(i).
FOLLOW YOUR LOCAL ELECTRICAL CODES!
Model 811, 813, 819, 821 Series
To the Installer
WARNING! Only install this machine in a
1
1-1