Taylor 811 Series Operator's Manual page 6

TO THE INSTALLER
WARNING! This machine must be properly
grounded! failure to do so can result in severe personal
injury from electrical shock!
1
IMPORTANT! This machine is provided with
an equipotential grounding lug that is to be properly
attached to the rear of the frame by the authorized
installer. The installation location is marked by the
equipotential bonding symbol (5021 of IEC 60417- 1) on
the removable panel and the frame.
IMPORTANT!
• Stationary machines which are not equipped
with a power cord and a plug or another device
to disconnect the machine from the power
source must have an all-pole disconnecting
device with a contact gap of at least 0.125 in.
(3 mm) in the external installation.
• Machines that are permanently connected to
fixed wiring, and for which leakage currents may
exceed 10 mA, particularly when disconnected
or not used for long periods, or during initial
installation, shall have protective devices to
protect against the leakage of current, such as a
GFI, installed by authorized personnel to local
codes.
• Supply cords used with this machine shall be
oil-resistant, sheathed flexible cable not lighter
than ordinary polychloroprene or other
equivalent synthetic elastomer-sheathed cord
(code designation 60245 IEC 57) installed with
the proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals
and protect the insulation of the conductors from
abrasion.
• If the supply cord is damaged, it must be
replaced by a Taylor service technician to avoid
a hazard.
• Secure the supply cord ground lead to the
machine in a location where if the cord is pulled,
the main power leads will become taut before
the ground lead can break loose.
1-2
Installation
WARNING! Read the installation, operating,
and maintenance instructions thoroughly before installing
or servicing this machine. This machine is designed for
indoor use only. 
Improper installation, adjustment, alteration, service, or
maintenance can cause property damage, injury, or
death.
WARNING! This machine must not be
installed in an area where a water jet or hose can be
used. Never use a water jet or hose to rinse or clean this
machine. Using a water jet or hose on or around this
machine may result in the electrocution of the user or
damage to the machine.

CAUTION! This grill must be installed on a
level surface. Failure to comply may result in personal
injury or machine damage.
Installation of Cable Kit
If the unit is permanently connected, the cable kit must
be installed. Flexible conduit must be used when
installing the appliance.

Model 811, 813, 819, 821 Series
To the Installer