Taylor 811 Series Operator's Manual page 38

OPERATING PROCEDURES
4. Put on heat-resistant gloves.
CAUTION! The upper platen surface and
release sheet are very hot. To prevent burn injuries, wear
heat-resistant gloves when replacing the release sheets.
5. Wipe the exposed surface of the release sheets with
a clean, sanitizer-soaked grill cloth.
6
6. Remove the release sheet clip, release sheet
retainer, and release sheet. Take them to the sink
area. Place the release sheet on a clean, flat surface
next to the sink.
6-16
Figure 6-46
Figure 6-47
Figure 6-48
Model 811, 813, 819, 821 Series
7. Repeat step 1 through step 6 for the remaining upper
platen(s).
14511
8. Wash and rinse the clips and retainers in the sink.
Set them aside for future use.
9. Leave the release sheets on the clean, flat surface
next to the sink until further cleaning is performed.
Do not fold, crease, submerge in water, or place
them on sharp objects.
14633
10. Scrape the lower grill surface with the grill scraper,
from front to back.
14354
Figure 6-49
Figure 6-50
Operating Procedures
14370
14505