Taylor 811 Series Operator's Manual page 13

CAUTION! For thorough cleaning, the grill
must be pulled away from the wall. Before moving the
grill, remove the grease cans. Turn off the gas at the
quick connect shutoff valve on the flexible hose.
Disconnect the gas quick connector. Disconnect the
tether to the grill, located on the back panel of the unit.
To return the grill to its original position, reverse the
steps. Use extreme caution to smoothly and slowly roll
the grill backward into place.
Failure to do so may cause the grill to tip and can result in
severe machine damage or personal injury.
NOTICE! Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please refer
to the cleaning section of this manual for the proper
procedure to clean this machine.
IMPORTANT! Access to the service area of
the machine is restricted to persons having knowledge
and practical experience with the machine, in particular
as far as safety and hygiene are concerned.
Safety
IMPORTANT!
• DO NOT obstruct the ventilation openings at the
rear of this machine.
• DO NOT obstruct the flow of air in and around
the grill.
attached to the grill to further point out safety precautions
to the operator.
This machine is made in America and has American
sizes on hardware. All metric conversions are
approximate and vary in size.
Noise Level: Airborne noise emission does not exceed
70 dB(A) when measured at a distance of 3.3 ft. (1.0 m)
from the surface of the machine and at a height of 5.25 ft.
(1.6 m) from the floor.
These instructions are valid only if the country code
symbol appears on the appliance. If the symbol does not
appear on the appliance, refer to the technical
instructions which give the necessary instructions for
adapting the machine to the utilization conditions of that
country.
Model 811, 813, 819, 821 Series
NOTICE! All warning labels that have been
SAFETY
3
3-3